Case:
The client said that the Samsung mobile hard disk was received on the computer, prompting that the installation driver was unsuccessful, and the indicator light was on, and it seemed that it did not flash.Later, the mobile hard disk got the other computer host to try the same failure, and the data cable was still faulty.After that, the mobile hard disk box was removed and the hard disk was hung from the disk. It was found that the motherboard BIOS could not recognize the hard disk.To save all the information in the hard disk.
Solution:
The engineer of the Data Recovery Center first excluded whether the hard disk body had traces of opening, falling over, and whether the circuit board had burned and overcurrent failure. Through the professional equipment PC3000 UDMA, the hard disk was powered on.The search is normal, but the state of the hard disk shows busy, and the PC3000 UDMA COM prompts XXLED. The diagnosis is caused by the damage of the firmware of the hard disk.The engineer of the Data Recovery Center uses professional equipment PC3000 UDMA to remove XXLED faults, repair the A list table of the hard disk, and then use the PC3000 UDMA de mirror, with a small amount of bad ducts, data recovery of about 99%, customer acceptance data is fulfilled.success.
