Seagate hard drive circuit board damaged in notebook water and recovery successfully

Case:
Ms. Yang’s notebook is the Windows operating system. The file system is NTFS/FAT, and the Hagivia hard disk model is WD5000BPKT capacity of 500GB; the notebook is placed on the table, and in the boot state, the colleagues accidentally sprinkled the water to the notebook, so they turned off, so they turned off, so they turned off, so they turned off, so they turned off.After drying it with paper, restart the computer and cannot enter the system.

Solution:
It was tested by engineers and was damaged by the circuit board.First evaluate the degree of damage to the hard disk circuit board; after the circuit board is repaired, the hard disk is connected to the detection equipment.Types, there may be physical bad ducts, firmware area problems, magnetic heads, motors, and even plate damage. At this time, it is necessary to further restore the solution of the corresponding faulty type; if the hard disk can be powered normally at this time, the magnetic head must be controlled by the device.After reading the relevant information of the hard disk, determine the information correctly, and the fault hard disk mirror can be used to be safe; the hard disk complete mirror backup of the device is logically analyzed and verified.