Case:
Mr. Huang uses an assembly desktop and uses 1TB Hitachi hard disk.In the process of using the computer, intermittent crashes often occur. Suddenly, after a crash, the computer could not enter the system, so I was preparing to reinstall the system, but how could the computer find this hard disk, and then I found that the hard disk was broken.Find data recovery center repair.
Solution:
The engineer of the data recovery center evaluates the detection of hard disk, the degree of damage to the circuit board, and after the circuit board is repaired, the hard disk is connected to the detection equipment.The single failure type of board damage may have physical bad sectors, firmware area problems, magnetic heads, motors, and even plate damage. At this time, it is necessary to further recover according to the corresponding faulty type solution.You must use the device to control the relevant information of the hard disk to read the hard disk. After the information is correct, the image of the faulty hard disk can be used to the safe storage;If the situation is not consistent, it is repaired according to the corresponding file system damage situation solution, and the data needed by the user finally migrates the data required by the user.