No jumpers need to be set to configure a SATA drive. Serial ATA connections take the guess work out of master/slave drive configuration, since the single drive point to point connection has been introduced.
The Serial ATA host automatically determines the master and slave hard drive.
Jumpers are small metallic pins that protrude from the end of a hard disc drive or from its circuit board, as shown below. Jumpers are used to configure the hard disc drive’s options, such as defining master and slave or cable select.
Every pin set has a specific numbering scheme, which is determined by its location on the drive. As shown above left, if the pins are on the circuit board, the pin number assignments are printed on the circuit board around the pins. As shown above right and below, if the jumper pins are on the end of the hard drive, Pin 1 will always be closest to the 4-pin power connector.
Below is a jumper shunt, which is used to connect two jumper pins. Connecting two jumper pins with a shunt completes an electrical circuit and enables or disables options of the hard drive. Extra shunts may be stored on a single pin as shown below because two or more pins must be connected by the shunt to complete the circuit and enable or disable options. When the shunt is only on one pin, it is not performing any function.
